Operating The Throttle; Operating The Ignition Switch - Toro GrandStand Multi Force 72524 Operator's Manual

Mower with 52in or 60in turbo force cutting unit and low flow hydraulics
Hide thumbs Also See for GrandStand Multi Force 72524:
Table of Contents

Advertisement

Disengaging the Power-Takeoff
(PTO) Switch
Figure 11
and
Figure 12
the PTO.
Figure 12
Note:
If you disengage the PTO by releasing the
motion-control levers, you can engage the PTO again
by pressing the O
position of the switch without
N
pressing the O
position first.
FF
show 2 ways to disengage
Figure 11

Operating the Throttle

You can move the throttle control between F
S
positions
LOW
Always use the F
g301401
Operating the Ignition
Switch
Important:
Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, wait 15 seconds between attempts. Failure
to follow these instructions can burn out the
g031593
starter motor.
Note:
You may need to repeat the cycle for starting
the engine when you start it for the first time after you
have filled a completely empty fuel system with fuel.
16
(Figure
13).
position when engaging the PTO.
AST
Figure 13
Figure 14
Figure 15
and
AST
g008946
g031239
g031281

Advertisement

Table of Contents
loading

This manual is also suitable for:

Grandstand multi force 72530414932857414800000

Table of Contents