Controls System Maintenance; Adjusting The Motion-Control Levers - Toro GrandStand Multi Force 72524 Operator's Manual

CAUTION
The spring is under tension when
installed and can cause personal injury.
Wear safety glasses and be careful when
removing the spring.
7. Remove the deck belt from the clutch and clutch
stop (Figure 72).
8. Install the new belt.
9. Install the tension spring and lower hydraulic
hose.
10. Install the drain plugs and torque to 22 to 27
N∙m (16 to 20 ft-lb).
11. Add hydraulic fluid to the fill level.
12. Install the hydraulic-reservoir cap.
13. Run the machine for 10 minutes and verify that
the hydraulic fluid is at the correct level.
Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the motion-control levers.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Push the motion-control levers down out of the
N -
EUTRAL LOCK
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
(Figure 73).
1. Left motion-control lever
2. Right motion-control lever
in the Neutral-lock position
Note:
To adjust the right motion-control lever
horizontally, adjust the cam.
5. Release the cushion from the rear of the
machine.
6. Loosen the nut holding the cam
48
position (Figure 73).
Figure 73
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure
g009436
74).