Table of Contents
Advertisement
10.
Insert the assembled nut and axle into the wheel
on the side of the wheel with the new seal and
bearing.
11.
With the open end of the wheel facing up, fill
the area inside the wheel around the axle full of
general-purpose grease.
12.
Insert the second bearing and the new seal into
the wheel.
13.
Apply a thread-locking adhesive to the second
spacer nut, threading it onto the axle with the
wrench flats facing outward.
14.
Torque the nut to 8 to 9 N∙m (71 to 80 in-lb),
loosen it, then torque it to 2 to 3 N∙m (20 to 25
in-lb).
Note:
Make sure that the axle does not extend
beyond either nut.
15.
Install the seal guards over the wheel hub and
insert the wheel into the caster fork.
16.
Install the caster bolt and tighten the nut fully.
Important:
To prevent seal and bearing damage,
check the bearing adjustment often by spinning
the caster wheel. The wheel should not spin freely
(more than 1 or 2 revolutions) or have any side
play. If the wheel spins freely, adjust the torque
on the spacer nut until there is a slight amount of
drag, and apply thread-locking adhesive.
Greasing the Engine
Voltage Regulator
Service Interval: Every 300 hours (More often if
grease is not present.)
Grease type: Dielectric grease
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Disconnect the spark plug wires from the spark
plug.
4.
Lightly apply grease to the voltage regulator
blades
(Figure
38).
Important:
Too much grease can cause
water to pool at the connector and short the
regulator.
5.
Connect the spark plug.
1. Voltage regulator
Greasing the Brake Calipers
Service Interval: Yearly
Apply a rust-preventative spray to the brake calipers
yearly.
1. Brake caliper
30
Figure 38
2. Regulator blades
Figure 39
g228035
g228033
Advertisement
Table of Contents
