Installing A Plug To The Flying-Lead Cord; Charging The Machine; Checking The Hydraulic-Fluid Level; Checking The Tire Pressure - Toro Groundsmaster e3200 Operator's Manual

12
Installing a Plug to the
Flying-Lead Cord
Optional
Parts needed for this procedure:
1 Flying lead power-supply cord
Procedure
Perform this procedure if you must use the flying-lead
cord as your power-supply cord
the machine.
Figure 13
Flying lead power-supply cord
1. Select a plug that has the following
characteristics:
•
Minimum current rating: 16 A
•
Rated for 250 V
2. Install the plug per the plug manufacturer
Installation Instructions.
Refer to the following table for the corresponding
wire color and circuit:
Wire Color
Green
White
Black
(Figure 13) to charge
g473358
Circuit
Ground
Neutral
Line
13

Charging the Machine

Parts needed for this procedure:
Power-supply cord (ordered separately; refer to your
1
authorized Toro distributor)
Procedure
1. Refer to your authorized Toro distributor for the
appropriate power-supply cord that can be used
in your country.
2. Charge the machine; refer to
Lithium-Ion Batteries (page
14
Checking the
Hydraulic-Fluid Level
No Parts Required
Procedure
Check the hydraulic-fluid level; refer to
Hydraulic-Fluid Level (page
15

Checking the Tire Pressure

No Parts Required
Procedure
Check the tire pressure; refer to
Pressure (page 29).
23
Charging the
39).
Checking the
53).
Checking the Tire Air