Crowd Density Detection - Speco N32NRE User Manual

Alarm Management
l Click to set the alarm linkage items after face match fails. The alarm linkage settings are the same as the sensor alarm (see 9.1 Sensor
Alarm for details).
③ Enable and click "Configure" under Stranger or Block List for the camera to set the alarm linkage items. The setting steps are similar to that of
the general configuration. Please refer to ② for details.

9.4.3 Crowd Density Detection

Only some versions may support this function. If your NVR doesn't support this function, please skip the following instructions.
Crowd Density Configuration:
Alarms will be triggered if the crowd density exceeds the set threshold value in the pre-defined area.
① Click StartàSettingsàCameraàSmart SettingsàCrowd Density to go to the following interface.
60
NVR User Manual