Homewhiz Setup - Beko B5DT59442W User Manual

To use the HomeWhiz function, the
app must be installed on your smart
device and your washing machine
must be connected to your home
network via bluetooth. If the
washing machine is not paired with
your smart device, it will work as a
device without the HomeWhiz
function.
Your product will work if paired
with smart device via Bluetooth.
The operation performed through
the application is activated with
this link. Therefore, the Bluetooth
signal between the product and
the smart device must be strong
enough.
Go to
www.homewhiz.com
Android and IOS versions
supported by the HomeWhiz app.
All safety precautions in the section
entitled "GENERAL SAFETY
INSTRUCTIONS"of the manual also
apply to the remote control with
the HomeWhiz function.
6.20.1 HomeWhiz setting
For the correct operation of the app, your
device must be connected to the
HomeWhiz app. To establish this
connection, you must follow the steps
below for configuration on your device and
the HomeWhiz app.
1. If you are adding a device for the first
time, tap on the "Devices" tab in the
HomeWhiz app. Select the "ADD
DEVICE" button (touch here to set up a
new device) in the top right corner.
Perform the configuration by following
the steps below and the steps in the
HomeWhiz app.
around the
NL/44
2. To start the configuration, your machine
must be switched off. Press and hold
the temperature button and remote
control function button at the same
time for 3 seconds to put your machine
into Home-Whiz setup mode.
3. When the device is in HomeWhiz setup
mode, you will see an animation on the
screen and the bluetooth icon will flash
until your machine pairs with the smart
device. Only the program button is
active in this mode.
The other buttons are inactive.
4. Follow the instructions on the screen of
the HomeWhiz app.
5. Wait for the installation to complete. At
the end of the installation you will need
to give your washing machine a name.
Now you can tap to display the product
you added in the HomeWhiz app.