Installation; Suitable Installation Location; Mounting The Lower Panel - Beko B5DT59442W User Manual

4 Installation

First read the chapter "Safety
instructions"!
Your washing machine
automatically detects the amount
of laundry placed in the machine
when a program is selected. During
the installation of the product,
before the first use, the machine
must be calibrated to ensure that
the amount of laundry is detected
as accurately as possible.
To do this, select the Drum
Cleaning* program and cancel the
Spin function. Start the program
without laundry. Wait for the end of
the program. This takes approx. 15
minutes.
* The name of the program may
vary depending on the model. For
the appropriate program selection,
please refer to the chapter with the
descriptions of the programs.
• Contact the nearest authorized service for
installation of your device.
• Make sure that the installation and
electrical connections of the product are
carried out by an authorized service
agent. The manufacturer cannot be held
responsible for damage caused by
procedures performed by unauthorized
persons.
• The preparation of the site and electrical,
water supply and drainage installations
at the installation site is the
responsibility of the customer.
• Make sure that the water inlet and drain
hoses as well as the power cable are not
folded, pinched or compressed when you
put the product in place after installation
or cleaning.
• Before installation, visually check whether
the product has any defects. Do not
install the device if it is damaged.
Damaged products can pose risks to your
safety.

4.1 Suitable installation location

• Place the product on a hard and flat floor.
Do not place it on a high carpet or other
similar surfaces. Placing the unit on an
inappropriate floor may cause noise and
vibration.
• Do not place the product on top of the
power cable.
• Do not install the product in places
where the temperature may drop below
0°C. Freezing can damage the product.
• Leave a minimum space of 1 cm between
the product and the furniture.
• If you want to install the product on a
surface with stairs, never place it close
to the edge.
• Do not place the product on a platform.
• There should be no doors with a latch,
sliding mechanism or hinges that could
prevent the loading door from fully
opening at the installation location of this
product.
• Do not place heat sources, such as
hotplates, irons, ovens, etc. on the
device and do not use them on the
product.
4.2 Fitting the lower panel covers
• To increase the sound comfort of the
product, attach cover A after removing
the packing foam.
NL / 15