Connecting The Drain Hose To The - Beko B5DT59442W User Manual

WARNING!
Single water supply models should
not be connected to the hot water
tap. In this case, the laundry will be
damaged or the product will switch
to protection mode and will not
work. Do not use old or used water
inlet hoses on the new product.
This can cause water leaks in your
machine and stains on your
laundry.
1. Connect the special water supply hose
supplied with the product to the water
inlet of the product.
WARNING!
Make sure that the cold water
connection is done correctly during
the installation of the product. If
not, your laundry may be warm at
the end of the wash cycle and thus
may not be wearable.
2. Tighten all nuts of the hoses by hand.
Never use a wrench when tightening
the nuts.
3. Open the taps fully after connecting
them to check for water leaks at the
connection points. If you notice any
leaks, turn off the tap and remove the
nut. Check the gasket and retighten the
nut carefully. Keep the faucets of the
product closed when not in use to
prevent water leaks and resulting
damage.

4.5 Connecting the drain hose to the

drain
1. Attach the end of the drain hose directly
to the drain hose, sink or bathtub.
Your home can be flooded if the
drain hose comes loose during the
draining of the water. There is a
risk of fire due to excessively high
washing temperatures. To avoid
such situations and to ensure that
the product supplies and drains
water smoothly, you must fix the
drain hose securely.
2. Connect the hose to a minimum of 40 cm
and a maximum of 90 cm.
3. If the hose is placed on the floor (or at a
maximum height of 40 cm from the
floor) and then at a higher height, it
may be difficult to drain the water and
the laundry may come out very wet.
Therefore, follow the heights listed in
the image.
4. To prevent drain water from flowing back
into the product and to ensure smooth
drainage, do not immerse the end of the
hose in the drain water or extend more
than 15 cm into the drain. If it's too long,
shorten it.
5. The end of the hose must not be bent,
stepped on or pinched
NL/17