Removing The Transport Protection Bolts; Connecting The Water Supply - Beko B5DT59442W User Manual

Lid A
Tilt the machine slightly backwards. Let
the tabs of cover A rest against the
bottom panel. Complete the assembly by
turning the cover.
• Cover B and the cap are optional. Fit
cover B and the cap if available.
Lid B
Let the tabs of cover B rest against the
bottom panel. Complete the assembly by
turning the cover.
Cap
Insert the cap by pressing it with your
finger.
4.3 Remove the transport protection
bolts
1. Loosen all transport safety bolts with an
appropriate wrench until they move
freely.
2. Bend the internal part by pressing it at
the gripping zones and pull out the
part.
3. Fit the plastic covers that come in the
bag with the manual into the holes on
the rear panel.
WARNING!
Remove the transport safety bolts
before using the product.
Otherwise, the product may be
damaged.
WARNING!
Keep the transport safety bolts in
a safe place so that you can move
the product again in the future.
Install the transport safety bolts in
the reverse order of the
disassembly procedure. Never
move the product without the
transportation safety bolts
securely in place.

4.4 Connecting the water supply

WARNING!
The water pressure required to
operate the product varies from
1-10 bar (0.1-1 MPa). To ensure
smooth operation of the machine,
10 - 80 liters of water must be
supplied in one minute from a fully
open tap. If the water pressure is
higher, you need to install a
pressure reducing valve.
EN / 16