Removing The Transit Bolts; Connecting The Water Supply - Beko HTV8716XWST User Manual

3.2 Packaging reinforcement
n
delete
DANGER!
• The product is heavy. Remove the
packing reinforcement as shown
in the picture.
• Be careful not to let your hand get
caught under the machine during
this procedure.
3.3 Removing the
transit bolts
a
PRECAUTION!
• Do not remove the shipping bolts before
removing the packing reinforcement.
• Remove the transport bolts before using
the washing machine! Otherwise, the
product will be damaged.
1
2
12 / NL
Tilt the machine
backwards to remove the
packaging reinforcement
to delete.
Remove the
packaging reinforcement
attached to the ribbon.
1 Loosen all bolts
using a wrench until
they
can rotate freely.
2 Remove the
transit bolts through
turning them slightly.
ng
C
INFORMATION
• Keep the shipping bolts in a safe
place for reuse if the product needs
to be moved again in the future.
• Never move the product without
properly fastening the transit bolts!

3.4 Connecting the water supply

C
INFORMATION
• The water supply pressure required to
run the product is between 1 and 10 bar
(0.1 – 1 MPa). It is necessary to get 10 –
80 liters of water from the fully open tap
in one minute for your product to work
properly. Fit a pressure reducing valve if
the water pressure is too high.
a
PAY ATTENTION!
• Models with single water supply
should not be connected to the hot
water tap. In this case, the laundry
will be damaged or the product will
switch to protection mode and not
work.
• Do not use old or used water
supply hoses on your
Washer Dryer / User Manual
3 Attach the plastic
3
caps that are
included in
the bag with the
user manual
into the holes on
the back panel.
This can stain
cause.
1 Close the with
the product
supplied
special hose
on the waterto
on the product
and on
feed
t.