2.1
Introduction
The following figures show the connectors on UNO-2484G. The following sections
give you information about each peripheral.
Figure 2.1 Front Panel of UNO-2484G for one stack model which can support
Figure 2.2 Front Panel of UNO-2484G for two stack model which can support
2.2
UNO-2484G Interface
The UNO-2484G four standard COM serial communication ports: COM1, COM2,
COM3, COM4. The setting can be adjusted in the bios page, the driver will be
installed automatically during OS installation.
2.2.1
COM Port Interface (COM1, COM2, COM3, COM4)
For UNO-2484G, 4 x RS-232/422/485, DB9, 50~115.2kbps.
2.3
LAN: Ethernet Connector
UNO-2484Gs are equipped with four Gigabit LAN controller. For the UNO-2484G, the
controller chip used is an Intel i210 Ethernet controller that is fully compliant with
IEEE 802.3u 10/100/1000 Base-T. The Ethernet port is a standard RJ-45 jack, and
LED indicators are on the front to show its Link (Green LED) and Active (Green LED)
status.
UNO-2484G User Manual
extra extension kit UNO-2484G-EKAE
extra iDoor module
6