Page 2
限用物質含有情況標示聲明書 Declaration of the Presence Condition of the Restricted Substances Marking 設備名稱 : 嵌入式工業電腦 型號 ( 型式 ):UNO-2483( 系列型號請參見次頁說明書 ) Equipment name Type designation (Type) 限用物質及其化學符號 Restricted substances and its chemical symbols 鉛 汞 鎘 六價鉻 多溴聯苯 多溴二苯醚 單元 Unit...
Page 3
限用物質含有情況標示聲明書 Declaration of the Presence Condition of the Restricted Substances Marking 設備名稱 : 嵌入式工業電腦 型號 ( 型式 ):UNO-2473G( 系列型號請參見次頁說明書 ) Equipment name Type designation (Type) 限用物質及其化學符號 Restricted substances and its chemical symbols 鉛 汞 鎘 六價鉻 多溴聯苯 多溴二苯醚 單元 Unit Lead Mercury Cadmium...
Page 4
No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of Advantech Co., Ltd. Information provided in this manual is intended to be accurate and reliable. How- ever, Advantech Co., Ltd.
Page 7
Because of Advantech’s high quality-control standards and rigorous testing, most of our customers never need to use our repair service. If an Advantech product is defec- tive, it will be repaired or replaced at no charge during the warranty period. For out- of-warranty repairs, you will be billed according to the cost of replacement materials, service time and freight.
Page 8
這是甲類測試產品,在居住的環境中使用時,可能會造成射頻干擾,在這種情況下, 使用者會被要求採取某些適當的對策 Technical Support and Assistance Visit the Advantech web site at www.advantech.com/support where you can find the latest information about the product. Contact your distributor, sales representative, or Advantech's customer service center for technical support if you need additional assistance. Please have the following information ready before you call: –...
Page 9
The sound pressure level at the operator's position according to IEC 704-1:1982 is no more than 70 dB (A). DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech disclaims all responsibility for the accuracy of any statements contained herein.
4 serial ports, 4 x GbE LAN, 4 x USB ports and Audio. UNO-2483G/ UNO-2473G supports two display types, VGA and HDMI for various high resolution requirements and also Advantech latest iDoor technology. The UNO-2483G/UNO-2473G can operate in wide temperatures (from -20 to 60°C for UNO-2483G/UNO-2473G).
Introduction The following figures show the connectors on UNO-2483G/UNO-2473G. The follow- ing sections give you information about each peripheral. Figure 2.1 Front Panel of UNO-2483G/ UNO-2473G-E3AE Figure 2.2 Rear Panel of UNO-2483G/UNO-2473G-E3AE Figure 2.3 Front Panel of UNO-2473G-J3AE Figure 2.4 Rear Panel of UNO-2473G-J3AE UNO-2483G/2473G Quick Start Guide...
UNO-2483G/UNO-2473G Interface (COM1~COM4) UNO-2483G/UNO-2473G offers two standard RS-232 and two RS-422/485 (with cable) serial communication inter-face ports: COM1 ~ COM4. The IRQ and I/O address range of COM1 to COM4 are listed below: COM1: 3F8h, IRQ4 COM2: 2F8h, IRQ3 COM3: 3E8h, IRQ10 COM4: 2E8h, IRQ5 The setting can be adjusted in the BIOS page, the driver will be installed automati- cally during OS installation...
LAN: Ethernet Connector UNO-2483G/2473G are equipped with four/two Gigabit LAN controllers. For the UNO-2483G and UNO-2473G-E3AE: The controller chip used is an Intel® i210-IT GbE Ethernet controller that is fully compliant with 802.1Qac, IEEE1588/802.1AS, 802.3az The controller chip used is an Intel® i218-LM GbE Ethernet controller that is ...
RTC Battery Specification The UNO-2483G/UNO-2473G has an RTC Battery to ensure the setting in BIOS and system clock can be kept, even with power disconnected for a short time. Type: BR2032 (Using CR2032 is NOT recommended) Output Voltage: 3 V ...
2.10 HD Audio UNO-2483G/UNO-2473G is equipped with ALC888S which is a High Definition Audio Codec. The UNO-2483G/UNO-2473G provides 2 phone jack connector for 5.1 chan- nel output. Please configure the function through the provided software utility. 2.11 PCI Express Mini Card Socket The UNO-2483G supports two sockets for full size PCI Express mini cards.
Page 23
Figure 2.7 UNO-2473G-E3AE mPCIe Location The UNO-2473G-J3AE supports two sockets for full size PCI Express mini cards. The first interface, CN16, is the default and defined ONLY for mSATA storage. The other interface is mainly targeted at supporting iDoor technology/modules for diverse applications such as isolated COM port, Profibus, WLAN GPRS, 3G, mRAM and iDoor Module.
Chapter Initial Setup This chapter introduces how to initialize the UNO-2483G/UNO- 2473G. Sections include: Inserting an mSATA Chassis Grounding Connecting Power Connecting a Hard Disk BIOS Setup and System Assignments...
Inserting an mSATA SSD Remove the power cord. Unscrew the six screws on the bottom cover. Plug an mSATA card with your OS and application program into the mPCIe slot. – UNO-2483G:CN14 with SIM card. – UNO-2473G:CN16 Screw the two screws on board to fix the mSATA. Screw back the bottom cover.
Installing a Hard Disk The procedure for installing a hard disk into the UNO-2483G/UNO-2473G is below. Please follow these steps carefully. Please note the system is not compatible with +12V HDD. Please use a HDD with lower power input. Remove the power cord. Unscrew the four screws from the bottom cover.
Installing a Wireless LAN Card and Antenna Please contact Advantech to prepare the following optional kit: Rear Panel for Antenna The internal cable: 1750006043 (15cm) Wireless Module (PCI Express mini card) One of the suggested module is EWM-W151H01E which is a verified Wireless ...
Page 29
Antenna Please select the necessary specification according to your application. One of the suggested antenna is 1750002842. Then follow the below steps for the installation: Unscrew the bottom panel and open it. Remove the hole(s) on the rear panel for antenna installation. Install the internal cable 1750006043 (15cm) on the rear panel.
Connect the internal cable with the module. Secure the bottom panel. Assemble the antenna on the SMA connector. BIOS Setup Press “F2” in the boot-up screen to enter the BIOS setup utility. Please follow the instruction on the screen to do the necessary settings. Please note that you can try to “Load Optimized Defaults”...
Page 31
Amt Wait Timer Set timer to wait before sending ASF_GET_BOOT_OPTIONS. Disable ME This item allows users to enable or disable ME. This item allows users to enable or disable ASF Configure Function. Activate Remote Assistance Process This item allows users to enable or disable PET event progress to receive PET events or not.
Teaming Configuration Please install the OS and LAN driver first. After entering the OS, please right click the mouse on Network adaptors to con- figure the Network Connection properties in the device manager. Set Teaming with other adapters in Teaming and then press New Team. UNO-2483G/2473G User Manual...
Page 33
Select the adapters to include in this team then press Next. Specify the name for the team then press Next. Select a team mode. Here Adaptive Load Balancing is chosen. UNO-2483G/2473G User Manual...
Finally, the wizard has the settings needed to create the team, and you'll find out the Network adapters will show as a team in the device manager. Enabling RAID in BIOS Press the DEL key after the Power-On-Self-Test (POST) memory test begins. Select the Advanced menu, then the SATA Configuration menu.
System I/O Address and Interrupt Assignment Table A.1: Interrupt Assignments Interrupt No. Interrupt Source Parity Error Detected IRQ0 System timer IRQ1 Standard 101/102-Key or Microsoft Natural PS/2Keyboard IRQ2 Interrupt from controller 2 (cascade) IRQ3 Communications Port (COM2) IRQ4 Communications Port (COM1) IRQ5 Communications Port (COM4) IRQ6...
Board Connectors and Jumpers There are several connectors and jumpers on the UNO-2483G/UNO-2473G board. The following sections tell you how to configure the UNO-2483G/UNO-2473G hard- ware setting. Figure A.1 shows the locations of the connectors and jumpers. Figure A.1 UNO-2483G Connector & Jumper Locations (front) Table A.2: Connectors and Jumpers Label Function...
Figure A.2 UNO-2473G Connector & Jumper Locations (front) Connectors and Jumpers Table A.3: Connectors and Jumpers Label Function CN14 CN15 PCI Express Mini Card Socket USB Pin Headers Battery for RTC CN29 ON/OFF/RESET Switch CN11 COM3, COM4 Turn On/Off Termination Resistors for COM3/COM4 No Function UNO-2483G/2473G User Manual...
RS-232 Standard Serial Port Table A.4: RS-232 Serial Port Pin Assignments Pin Name RS-422/485 Serial Port Table A.5: RS-422/485 Serial Port Pin Assignments RS-422 RS-485 Data- Data+ UNO-2483G/2473G User Manual...
USB Connector Table A.7: USB 2.0 Connector Pin Assignments Signal Name Cable Color DATA- White DATA+ Green Black Table A.8: USB 3.0 Connector Pin Assignments Signal Name Description VBUS Power USB2.0 differential pair Ground for power return StdA_SSRX- SuperSpeed receiver differential pair StdA_SSRX+ GND_DRIAN Ground for signal return...
Need help?
Do you have a question about the UNO-2483 and is the answer not in the manual?
Questions and answers