Attaching The Hoop; Overview Embroidery Functions; Center The Needle To The Embroidery Hoop - Bernina B 500 User Manual

Embroidery preparation
> To avoid scratches on the free arm, press the inner hoop into the outer hoop so that the inner hoop

Attaching the hoop

> Raise the needle.
> Raise the embroidery foot.
> Hold the hoop with the right side of the fabric up with the attaching mechanism to the left.
> Position the hoop below the embroidery foot.
> Press both attaching mechanisms (1) of the hoop towards each other.
> Position the embroidery hoop (2) above the bracket of the embroidery arm.
> Press the hoop down until it clicks in position.
> Release the attaching mechanism (1).
> Press the attaching mechanisms of the hoop towards each other to remove the hoop.
> Remove the hoop.

Overview embroidery functions

1
2
3

Center the needle to the embroidery hoop

Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Touch the icon «Center the needle to the embroidery hoop».
> Threading the upper thread.
P
48
including the fabric protrudes downwards by up to 1 mm.
2
1
Centering the embroidery hoop to the needle 4
Moving the embroidery hoop to the back
Moving the embroidery hoop to the left
1
1
2
3
4
5
Grid on/off
5 Center of embroidery motif
6 Virtual positioning (appears by scrolling)