Table of Contents
Advertisement
Step 3:
Assembly of the Seat and Back Frame
1.
Mount the seat frame (11) to the front upright (4) with two bolts (88), four washers (101) and
two nuts (107).
2.
Mount the seat frame (11) to the base frame (1) with one bolt (87), two washers (101) and one
nut (107).
3.
Mount the leg extension arm (12) to the seat frame (11) by aligning the holes and inserting the
leg extension axle (33). Fasten the leg extension axle (33) with two spring washers (104), two
washers (102) and two set screws (97). Ensure that the leg extension arm (12) pivots freely.
4.
Mount the right and left leg extension arms (12R & 12L) to the leg extension arm (12) with the
set screw (98A).
5.
Moisten the inside of the foam pads (75A) with water and attach one foam pad (75A) to each
end of the right and left leg extension arms (12R & 12L). Fasten the foam pads (75A) with one
plastic cover (45), one plastic washer (45A), one large washer (129) and one sunken head screw
(116) each.
NOTICE
L
The L pin (55) is used to lock the leg extension arm (12) into place when using the low cable for
exercises such as arm curls, leg kicks, upright rows etc. Remove the L pin (55) when performing
leg extensions or leg curls.
6.
Insert one foam roller bar (23) through the hole of the chromed seat adjuster (16). Moisten the
inside of the foam pads (75A) with water and attach one foam pad (75A) to each end of the foam
roller bar (23). Fasten the foam pads (75A) with one plastic cover (45), one plastic washer (45A),
one large washer (129) and one sunken head screw (116) each.
7.
Mount the seat pad (77) to the chromed seat adjuster (16) with two bolts (92) and two washers
(101). Attach one plug (44) to the chromed seat adjuster (16). Insert the chromed seat adjuster
(16) into the seat frame (11) and lock it into place with one spring (115) and the spring knob (53).
8.
Mount the seat back adjuster (17) to the front upright (4) with one bolt (88), two washers (101)
and one nut (107). It might be necessary to tighten and then loosen the bolt just enough so the
seat back adjuster (17) pivots freely.
9.
Insert the pop pin (51) for the seat back adjuster (17) into the front upright (4). Attach two metal
hinges (19) to the top of the seat back adjuster (17) and then mount the back pad (76) to the
metal hinges (19) with two bolts (93) and two washers (101).
10. Insert one foam roller bar (23) into the hole of the seat back adjuster (17). Moisten the inside of
the foam pads (75A) with water and attach one foam pad (75A) to each end of the foam roller
bar (23). Fasten the foam pads (75A) with one plastic cover (45), one plastic washer (45A), one
large washer (129) and one sunken head screw (116) each. Lock into place with the pre-installed
screw.
11. Mount the weight shrouds (28) to the base frame (1) and the top guide rod retainer (7) with four
bolts (95) and four washers (102) each.
12. Attach two bindings of weight shroud (83) to each weight shroud (28).
13. Gradually tighten all bolts and nuts.
16
X-Press Pro
Advertisement
Table of Contents
