Troubleshooting, Care And Maintenance; General Instructions; Faults And Fault Diagnosis - BodyCraft SW-95.0202 Assembly And Operating Instructions Manual

4

TROUBLESHOOTING, CARE AND MAINTENANCE

4.1

General Instructions

⚠ WARNING
+ Do not make any improper changes to the equipment.
CAUTION
⚠
+ Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
࣑ ATTENTION
+ In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
4.2

Faults and Fault Diagnosis

The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault
Grinding noises
Weight hanging in
the air
Cable without tension
Squeaking & cracking
noises
Unit wobbles
Heavy draught
* With a grease-free silicone oil or silicone spray.
34
Cause
Cables or pulleys do not run
smoothly or are damaged
Cable tensioned too tight
Cable too loose
Screw connections loosened
or too tight
+ Uneven ground
+ Loose screw connections
+ Weight holders/guide
rods too dry
+ Faulty cable routing
Solution
+ Visual inspection of the cable routing
or the pulley guide
+ If damaged, replace the defective
part
Readjust cable tension
+ Check cable routing
+ Readjust cable tension
+ Check or lubricate
connections*
+ Check cable routing
+ Align unit
+ Tighten screw connections
+ Lubricate guide rods*
+ Check cable routing
X-Press Pro
screw