Table of Contents
Advertisement
2.3
Assembly: Multi-gym
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
NOTICE
L
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1:
Assembly of the Main Frame
1.
Mount the rear stabilizer (2) to the base frame (1) with two bolts (88), four washers (101) and
two nuts (107).
2.
Mount the front stabilizer (10) and the low row connector (13) to the base frame (1) with two
bolts (85) and two nuts (106).
3.
Attach one cap (40) to each end of the front and rear stabiliziers (10 & 2).
4.
Stick four non slips (70) to both sides of the foot plate (14) and mount the foot plate (14) to the
low row connector (13) by aligning the holes and inserting the foot plate roller (15).
5.
Insert one plug (46) into each end of the foot plate roller (15).
6.
Mount the rear upright (3) to the rear stabilizer (2) with two washers (100) and two nuts (106).
7.
Mount the front upright (4) to the base frame (1) with two bolts (88), four washers (101) and
two nuts (107).
8.
Mount the top frame (5) to the front upright (4) with two bolts (84) and two nuts (106).
9.
Mount the top frame (5) to the rear upright (3) with two bolts (85) and two nuts (106).
10. Insert four plastic guide rod holders (47) into the base frame (1) and into the top guide rod
retainer (7).
11. Insert the guide rods (6) into the guide rod holders (47).
NOTICE
L
If you have 14 weight plates (fig. 2), the weight stack spacers (130) must be installed (fig. 2). If
you have 19 weight plates, discard the weight stack spacers (130) (fig. 1).
12. Slide one weight stack spacer (130) and one rubber donut (63) over each of the guide rods (6).
13. Carefully slide each of the 10 LB weight plates (68) over the guide rods (6) one by one. Make sure
that all weight plates are facing forwards with the hole at the bottom.
14. Mount the selector rod (69) to the top plate (67) with the top plate bolt (109). Carefully slide the
top plate (67) with the selector rod (69) over the guide rods (6).
15. Insert the magnetic selector pin (54) into the weight stack.
16. Mount the top frame connector (5A) to the top frame (5) with two bolts (85A) and two washers
(100).
17. Slide the top guide rod retainer (7) over the guide rods (6) and mount the top guide retainer
(7) to the top frame connector (5A) with two bolts (89), four washers (101) and two nuts (107).
18. Attach a plug (41) to the rear upright (3) and one plug (43) to the rear side of the top frame (5).
13
Advertisement
Table of Contents
