Table of Contents
Advertisement
Step 5:
Assembly of the Ab Crunch Cable (4360mm)
࣑ ATTENTION
During assembly, always place the cables over or under the pulleys and only then mount the
covers. It is not always possible to pass the cables through afterwards!
Insert the ab crunch cable (78) through the slot in the front upright (4) and pass the cable as followed:
+
over the pulley in the front upright (4) [FIG1]
+
down to the front pulley on top of the cable arm connector (20A) [FIG2]
+
up and over the lower pulley in the adjustable pulley block (25) [FIG3]
+
down to the rear pulley on the cable arm connector (20A) [FIG4]
+
further to the rear pulley on the base frame (1) [FIG5 & FIG6]
+
forward to the leg extension arm (12). Ensure that the cable runs below both pulleys on the base
frame (1) as well as the pulley on the leg extension arm (12).
20
X-Press Pro
Advertisement
Table of Contents
