Table of Contents
Advertisement
Step 4:
Assembly of the Top Cable (4600mm)
࣑ ATTENTION
During assembly, always place the cables over or under the pulleys and only then mount the
covers. It is not always possible to pass the cables through afterwards!
Insert the threaded end of the top cable (80) into the slot in front of the top frame (5) [FIG1] and pass
the cable as followed:
+
over the top pulleys in the top frame (5) [FIG1 & FIG2]
+
over the left pulley (as if sitting on the seat) in the press arm selector (8) [FIG3, STEP1]
+
under the pulley in the frount upright (4)
+
over the right pulley in the press arm selector (8) [FIG3, STEP2]
+
over the pulley in the front upright (4) [FIG4]
+
down to the top pulley in the adjustable pulley block (25) [FIG5]
+
up and over the left pulley in the top frame (5) [FIG6]
+
down and around the top pulley in the adjustable pulley block (25) [FIG7]
+
up and over the two rear pulleys in the top frame connector (5A) facing the weight stack [FIG8]
Screw the cable end into the selector rod (69) [FIG9].
18
X-Press Pro
Advertisement
Table of Contents
