Table of Contents
Advertisement
Step 2:
Assembly of the Press Arm and Cable Arm Assembly
1.
Mount the press arm selector (8) to the top frame (5) by aligning the holes and inserting the axle
(31A), locking it into place with the pre-set screw.
2.
Mount the press arm (9) to the press arm selector (8) by aligning the holes and inserting the pivot
axle (31), locking it into place with the pre-set screw.
3.
Attach one plug (41A) to each end of the press arm (9) and one plug (41) to each end of the press
arm selector (8).
4.
Mount the cable arm connector (20A) to the cable arm assembly (20) with two bolts (93) and two
washers (101).
5.
Mount the cable arm connector (20A) to the front upright (4) and the base frame (1) with two
bolts (88), four washers (101) and two nuts (107) each. Keep the bolts loosely tightened in order
to align the holes easily.
6.
Slide the axle of each cable arm (21) through the hole in the selector plate of the cable arm
assembly (20) and fasten with the axle collar (36) and set screw (99). Ensure that the arms pivot
freely and no cables are twisted.
7.
Mount the lat bar holder (18) to the top frame (5) with two bolts (88), four washers (101) and
two nuts (107).
15
Advertisement
Table of Contents
