Table of Contents
Advertisement
Step 6:
Assembly of the Cable Arm Connecting Cable (4700mm)
࣑ ATTENTION
+
During assembly, always place the cables over or under the pulleys and only then mount
the covers. It is not always possible to pass the cables through afterwards!
+
If you have purchased the optional leg press, do NOT use the cable arm connecting arm
(4700mm), use the leg press cable instead.
Mount one pulley to the base frame (1) near the weight stack [FIG1]. The ball end of the cable must
be facing towards the weight stack. Pass the cable as followed:
+
up and over the lower pulley of the adjustable pulley block (25) [FIG2]
+
down to the pulley on the base frame (1) [FIG3]
+
up and over the right pulley on the top frame (5) [FIG4].
Screw the threaded end of the cable into the single pulley block (27) [FIG5].
21
Advertisement
Table of Contents
