Table of Contents
Advertisement
Step 8:
Cable Adjustment
The cables should be tightened to the point just before the top plate lifts off the weight stack. If the
top plate is not resting on the weight stack, you must add length. If the cables are slacking, you must
shorten the length. There are several adjustment points, depending on whether only minor or larger
adjustments are needed.
Minor Adjustments
For minor adjustments, you can adjust the screw ends on the top cable (at the top plate) and the
cable arm connecting cable (where it screws into the pulley block). Once adjusted, lock them into
place with the jam nuts.
⚠
CAUTION
These ends must always be screwed in at least 1/3 of their length.
Coarse Adjustments
Coarse adjustments are made at the adjustable pulley block (25). Move the bottom pulley towards
the center to descrease/tighten the length. Move the bottom pulley downwards to increase/loosen
the length.
Once the cables have been adjusted to remove all slack, adjust the adjustable stoppers in the top
frame to the point where they just touch the adjustable pulley block (25).
25
25
23
Advertisement
Table of Contents
