Setting Platform Drain Position - 3D Systems SLA 750 Series User Manual

Note: If the Start Position is not set, the elevator will move to the original default Start Position during
printing.
Any time the print platform is removed and reinstalled, it is advised that Move to Start be selected to make sure that all settings
have been retained for optimal printing. If not, you will need to repeat the preceding steps to reset your Start Position.
Note: After setting the Start Position, there may be bubbles in the MDM. Bubbles must be removed before
printing. To remove bubbles, follow the instructions here.

6.5.2 Setting platform drain position

Setting the Drain Position will be determined by the
To set the Drain Position:
1. From the UI, tap on Elevator & Recoater (1) near the bottom tray and tap on More Settings.
3D Systems, Inc.
Start Position value.
42 p/n 40-D150, Rev. C