3D Systems SLA 750 Series User Manual page 45

1. Visual determine if the print platform is either just above or just below the resin level.
2. Tap on the Move Increment box (4) icon under the Elevator section.
3. Enter either a value of ± 0.05 in the Move Increment (4) box and tap Move (5)until the print platform and resin level are at
the optimal position (See Figure B).
4. Tap Level Material again.
5. Visual determine if the print platform and resin level are at the optimal position (See Figure B). If not, repeat steps 6 and 7.
6. Once you are satisfied with the print platform height, tap Set To Current Position under the Elevator Settings (6).
3D Systems, Inc. 41 p/n 40-D150, Rev. C