Table of Contents
Advertisement
Troubleshooting Paper Feed
Printing Labels
Thermo Scientific
If the paper does not feed properly (no paper comes out from the top of the printer),
remove the paper from the printer and repeat steps
To remove paper from printer
1. Unplug the power supply to printer.
2. Open the panel from back of printer by pushing the two release buttons on either
side of the paper holders while simultaneously pulling the panel up.
Once the panel has been removed, you will see a green rocker switch on the
right side of the roller.
3. Press switch down to release paper (see
4. Pull paper gently out of the printer.
Push the green switch up to the horizontal position once paper has been
removed.
Note Ensure you return switch to horizontal position before you put the panel
on.
5. Snap back panel into place.
6. To reload paper plug in the power supply to printer and repeat the steps in
load paper into printer"
When the instrument is connected to the printer, there are three ways to print sample
labels:
• If Autoprint is ON, a label will print automatically after each sample measurement.
• To change Autoprint navigate to Home > Settings > Printer. Toggle Autoprint
Enabled or Autoprint Disabled.
• When Autoprint is turned off, select Print after measuring a sample.
• If additional labels are required, select Print again.
• Select Print
when viewing results from previously measured samples in the
Sample History screen (Home > History).
Using NanoDrop Lite Plus With Optional Printer
"Printing Labels"
on
page
22.
NanoDrop Lite Plus User Guide
1
NanoDrop Lite Plus User Guide
6
through 9.
on
page
25).
"To
25
Advertisement
Table of Contents
