Table of Contents
Advertisement
User's Manual
Chapter 5 Troubleshooting
Possible faults in use of UT1000X and troubleshooting methods are listed below. Please handle fault as the
corresponding steps. If it cannot be handled, please contact with the distributor or local office and provide the
model information (press Utility
5.1 No Display on Screen(Blank Screen)
If the waveform generator is blank screen when press the power switch on the front panel.
Inspect whether power source is connected well.
1)
Inspect whether power button is pressed.
2)
Restart the instrument
3)
If the instrument still can't work, please contact with the distributor or local office for product
4)
maintenance service.
5.2 No Waveform Output
In correct setting but the instrument has no waveform output display.
Inspect whether BNC cable and the output terminal is connected well
1)
Inspect whether CH1, CH2 button is turned
2)
If the instrument still can't work, please contact with the distributor or local office for product
3)
maintenance service.
Chapter 6 Service and support
6.1
Maintenance and Cleaning
(1) General Maintenance
Keep the instrument away from the direct sunlight.
Caution
Keep sprays, liquids and solvents away from the instrument or probe to avoid damaging the instrument
or probe.
(2) Cleaning
Check the instrument frequently according to the operating condition. Follow these steps to clean the
external surface of the instrument:
a. Please use a soft cloth to wipe the dust outside the instrument.
b. When cleaning the LCD screen, please pay attention and protect the transparent LCD screen.
Instruments.uni-trend.com
System
About to check).
.
on.
UTG1000X Series
65 / 74
Advertisement
Table of Contents
