Table of Contents
Advertisement
User's Manual
4.2.3 Frequency Sweep Mode
Press
Sweep
Linear: waveform generator
Logarithmic: waveform generator change the output frequency in logarithmic way.
4.2.4 Frequency Sweep Time
In frequency sweep mode, the frequency sweep time (the range is 1ms- 500s), the default is 1s. It can be
change by press soft key
complete the setting.
4.2.5 Comprehensive Example
In frequency sweep mode, set an internal square wave with amplitude 1 Vpp, duty cycle 50% as the frequency
sweep wave. Frequency sweep mode is set to linear, set the start frequency to 1 kHz, stop frequency to 50
kHz, sweep time to 2ms, use internal source trigger to output the frequency sweep wave.
The setting steps as follows.
1) Enabling Linear Sweep Mode
Press Mode
2) Select Frequency Sweep Wave
Press Wave key to enter the sweep frequency wave interface and select square wave (the default is sine
wave).
Instruments.uni-trend.com
key to select linear or logarithmic;
outputs frequency in a linear way during frequency sweep;
Time
and use numerical keyboard to input number and select unit soft key to
Sweep
Linear
to turn on linear sweep mode.
UTG1000X Series
54 / 74
Advertisement
Table of Contents
