Table of Contents
Advertisement
User's Manual
Press Wave
the parameter to
3.1.7 DC
The default DC is 0 V.
The specific steps to change DC to 3 V,
Press Wave
parameter to V.
3.1.8 Noise Wave
The default amplitude is 100mVpp, DC offset is 0 V quasi Gaussian noise.
Take the setting of quasi Gaussian noise with amplitude 300mVpp, DC offset 1 V as an example,
Press Wave
the unit of the parameter to
unit of the parameter to
3.1.9 Power Output
The full bandwidth of built-in power pre-amplifier can reach to 100 kHz, the maximum output power 4W,
output slew rate is greater than 18V/μs.
press CH2
PA Output
output interface is on the rear panel, BNC port.
3.2 Auxiliary Function
Utility can set the frequency meter, system, power for CH1 and CH2. The specific function as shown in the
following table.
3.2.1 Channel Setting
Function Menu
CH1, CH2 setting
Instruments.uni-trend.com
Ramp
Symmetry
key in turn, use numerical keyboard to input 75
%
.
Next Page
DC
key in turn, use numerical keyboard to input 3
Next Page
Noise
Amp
mVpp
, press
V
.
On. Power output is enabled which means the power pre-amplifier output is activated,
Function Sub-menu
Channel output
Channel reverse
Sync output
On-load
Amplitude limit
Upper limit of amplitude
Lower limit of amplitude
key in turn, use numerical keyboard to input 300
Offset
key, use numerical keyboard to input 1
Setting
OFF, ON
OFF, ON
CH1, CH2, OFF
50Ω,
high impedance
OFF, ON
UTG1000X Series
and
then select the unit of
and
then select the unit of the
and then
and then
select the
Description
1Ω to 999Ω
To set the upper limit
for amplitude output of
the channel
To set the lower limit
for amplitude output of
the channel
select
17 / 74
Advertisement
Table of Contents
