Service Manual
Service level
This section contains information and procedures to help you determine if a power failure is an instrument
problem. If the power fails, the instrument needs to be sent back to the Uni-Tech service center for repair,
because other internal electronic components or modules cannot be replaced by the user.
Frequently Asked Questions
Use the following table to help isolate possible failures. The following table lists problems and possible
causes. This list is not exhaustive, but it can help eliminate quick-fix issues, such as a loose power cord. For
more detailed troubleshooting, see Troubleshooting Flowchart
Symptoms
The instrument cannot be powered on
The instrument is powered on, but the fans
are not running
The display is blank or there are streaks in
the display
Required equipment
Digital voltmeter for checking mains voltage.
•
Anti-static working environment.
•
Troubleshooting flowchart
The flowchart below describes how to troubleshoot the instrument in the most general cases. This does not
guarantee full recovery from all possible hardware failures.
Instruments.uni-trend.com
Possible reason
Power cord not plugged in
•
electricity failure
•
Defective Microcontroller Components
•
Faulty fan power cable
•
Fan power cable not connected to circuit board
•
fan failure
•
electricity failure
•
One or more defective load regulator points
•
• Display or display circuit failure.
UTG1000X Series
18 / 20