UNI-T UTG1000X Series User Manual page 58

User's Manual
Table 4-3
Carrier Wave
Sine Wave
Square Wave
Ramp Wave
Pulse wave
Arbitrary
Wave
If the frequency of the wave need to be set, please select the wave at first, and then use multifunction rotary
knob or press soft key
soft key to complete the setting.
Pulse String Type
4.3.2
UTG1000X can output three types of pulse train, N cycle, gating and infinite. The default type is N cycle.
1) N Cycle Mode
Press NCycle
number (pulse string). After output a designated number cycle number, the waveform generator will stop
and wait for the next trigger. The trigger source of pulse string can be internal or external in this mode. It
can be change by multifunction rotary knob and arrow keys or press soft key
setting (as shown in the following figure).
2) Gating Mode
Gate
Press
parameter list will be automatically hidden. So it can only use the external trigger source, the waveform
Instruments.uni-trend.com
UTG1042X
Minimum Value
1 μHz
1 μHz
1 μHz
1 μHz
1 μHz
Freq
to set the frequency, use numerical keyboard to input number and select unit
to enter N cycle mode, the waveform generator will output a waveform with designated cycle
to enter gating mode, the trigger source, trigger edge, burst and cycle number options in the
Frequency
Maximum Value Minimum Value
40 MHz 1 μHz
20 MHz 1 μHz
1 MHz 1 μHz
20 MHz 1 μHz
10 MHz 1 μHz
UTG1022X/-PA
Maximum Value
20 MHz
10 MHz
400 kHz
10 MHz
5 MHz
TrigSrc
UTG1000X Series
to complete the
58 / 74