User's Manual
is sine wave).
Press Freq soft key to set the frequency, use numerical keyboard to input 900 and then select the unit of
parameter to Hz;
Press Amp soft key to set the amplitude, use numerical keyboard to input 100 and then select the unit of
parameter to
4) Set Phase Deviation
After the parameter setting of the carrier wave is completed, press Mode
setting,
Press
PhaseDev
to °
.
Instruments.uni-trend.com
mVpp. As shown in the following figure.
soft key and use numerical keyboard to input 200 and then select the unit of
Shape
PM
to enter PM mode
parameter
UTG1000X Series
34 / 74