Connection; Connecting To A Terrestrial Antenna; Connecting To Tv With Hdmi Cable; Connecting To Tv With Scart Cable - Strong SRT 8208 User Manual

Digital terrestrial hd receiver

Table of Contents

3.0 CONNECTION

To receive broadcast signal, your terrestrial indoor or outdoor antenna must be connected to the ANT IN

connector on the back of the receiver. Use a properly shielded antenna cable and suitable connectors.

The TV set shall be connected with the receiver using a good quality HDMI 1.3 or higher cable. This

connection gives the highest possible quality.

The unit is also equipped with a SCART connector; alternatively, the TV set can be connected to the

receiver using a good quality SCART cable.

By connecting your receiver to a digital amplifier or home theatre system, you can enjoy the best

possible sound quality and multi-channel audio (depending on broadcast) up to Dolby Digital. Connect

your Digital Audio Amplifier or home theatre system with a suitable cinch cable to the S/PDIF connector

on the back of the receiver.

By connecting your receiver to the latest digital amplifiers or home theatre systems with HDMI

connections, you will enjoy the best possible sound quality and multi-channel audio (depending

on broadcast), up to Dolby Digital Plus. Connect the HDMI output of the receiver to an input of your

amplifier, and then connect the HDMI output of the amplifier to your TV set. Select the correct input on

your amplifier to watch and listen to programmes.

NOTE:

For proper functioning of Timeshift and recording functions, a fast USB device (such as a hard disk drive)

is needed. Interrupted playback or a distorted picture during playback or Timeshift are indications for a

low device speed. STRONG cannot guarantee proper functioning of recording and or Timeshift functions

with all USB devices.

We recommend the use of a hard disk drive USB 2.0 for recording and play

back of TV events.

Fig. 6

Fig. 7

Fig. 8

Table of Contents