Removing/Replacing The V-Belts - Craftex CX Series User Manual

To Replace the V-Belts
Follow the instructions 1-5 to access the
V-belts.
6.
Loosen the motor lock lever shown
in figure-38 and idler pulley
mounting nut shown in figure-39.
Figure-38 Motor lock lever
Figure-39 Idler pulley mounting nut
7.
Pivot the motor and slide the idler
pulley to loosen up the belt.
8.
Remove the old belt and install the
new one.
9.
Slide the idler pulley down to tighten
the lower wheel V-belt. Keep pressure
on the idler pulley and tighten the
mounting nut.
10.
Check the wheel pulley V-belt if
tensioned properly. If tension is nec
essary, pivot the motor to tighten the
motor V-belt. Keep pressure on
the motor and tighten the motor ad
justment bolt.
11.
Check the motor V-belt, if properly
tensioned and tighten the motor
hinge bolt.
12.
Install back the wheel, blade and close
the cabinets.
WARNING
When installing I removing and servicing
any part of the machine, make sure the
power switch is in the off position and the
cord is disconnected from the power
source. Failure to do so may result in
serious personal injury or death .