Replacing The V-Belts - Craftex CX100 User Manual

Figure-40 Lower wheel and pulleys
To Replace the V-Belts
4. Follow the instructions 1-3 to access
and inspect the V-belts.
5. Loosen the motor bracket lock and
bolt, shown in figure-41 and idler
pulley mounting nut shown in figure-
42.
Figure-41 Loosening motor bracket lock
24
Figure-42 Idler pulley mounting nut
6. Pivot the motor and slide the idler
pulley to loosen the belt.
7. Remove the old belt and install the
new one.
8. Slide the idler pulley down to tighten
the lower wheel V-belt. Keep pressure
on the idler pulley and tighten the
mounting nut.
9. Check the wheel pulley V-belt if
tensioned properly.
necessary, pivot the motor to tighten
the motor V-belt. Keep pressure on the
motor and
adjustment bolt.
10. Check the motor V-belt, if properly
tensioned, and then tighten the motor
hinge bolt.
11. Install back the wheel, blade and close
the cabinets.
WARNING
All adjustments should be done with the
power off. Failure to do so may result in
serious personal injury or death.
If tension
tighten the motor
is