Craftex CX Series User Manual page 15

Figure-20 Set Screws
Adjust the bearings so that the space
between the guide bearing and the blade
should be 0.02" which is thickness of a sheet
of paper. See figure-22
Now, retighten the set screws to lock the
guide bearings in place.
Loosen the lock levers shown in figure-23
and move the guide shafts in or out so that
the guide bearings are 1/32" behind the
blade gullet teeth and the thrust bearing,
is 1/64" behind the back edge of the blade.
Once the bearings are at the correct
position behind the blade, tighten the lock
lever to lock the bearings in place.
See figure-23.
Figure-21 Table sitting on the table stop
Figure-22 Distance of the bearings behind
the blade.
Adjust the lower bearings in the same
manner.
Table Stop Adjustment
See figure-21 for reference.
CX108N features a table stop which allows
the table to easily come to a 90° if the table
is tilted.
To adjust the table stop so that the table sits
at 90°, you should first make sure the switch
is in "OFF" position and the power cord is
unplugged. Loosen the two lock knobs
under the table and loosen the hex nut
which locks the table stop bolt.
Now, place a square on the table as shown
in figure-23 and adjust the table stop so that
the table is at a 90° with the blade.