Craftex CX Series User Manual page 11

Figure-11 Front fence rail installed
Now take the fence and lift up the handle.
Place the fence on the front fence rail until it
touches against the blade.
Use a pencil to mark the fence rail where the
fence scale indicator on the right hand side is
pointing (there is a gap just behind the
indicator plate where you can mark the rail).
This mark will indicate where to align the O"
mark when install the scale.
Now, remove the fence from the rail and
install the adhesive backed scale on the front
fence rail.
Figure-12 Adhesive backed scale attached
to the front rail
Once you have attached the adhesive backed
scale to the rail, place the fence on the rail
and tighten it in place by pushing down the
handle. See figure-14
Figure-13 Fence installed on the rails
Attach the miter gauge holder and the
fence holder to the back of the saw using
screws and washers provided see figure-14
Fence Holder
Miter Gauge
Holder
Figure-14 Miter gauge holder and fence
holder installed