Craftex CX Series User Manual page 10

Place the washer #60 on the knob #170.
Pass the threaded stud of the knob through
the slot in the angle adjustment plane. Then
install the spacer on the threaded stud of
the knob and then thread the knob into the
body of the band saw.
Tighten the knob to secure the table at the
desired angle required for your cutting
operation.
Install the table insert at the center of the
table and the table pin into the table slot as
shown in figure-8.
Figure-8 Installing table insert and
table pin
10
Figure-9 Rear rail brackets attached
Now, attach the rear rail to the brackets
using the knobs provided. See figure-11.
Figure-10 Installing the rear fence rail
Take the rail bracket (smaller) and attach it
to the table using cap screws provided. See
figure-9 .
Take the rail brackets (larger) for the front
fence rail and attach it to the table using the
cap screws provided.
Place the front fence rail on the brackets and
insert the knobs through the hole on each
bracket and thread the square nuts onto the
ends of the knobs a couple of turns to
tighten the fence rail
in place. See figure-11.