Dexter Laundry T-750 C4 Installation And Parts & Service Manual page 68

Inverter Drive Motor removal
1.) Remove power from the machine by turning off the circuit breaker.
2.) Remove Rear Control box cover by removing the two 5/16 screw.
3.) Remove rear belt guards.
4.) Disconnect Motor wires; T1, T2, and T3 from the inverter drive, and the ground screw from the control
box.
5.) Remove Tumbler pulley belt to release tension on the motor tension chain and motor.
6.) Remove motor tension spring and chain.
7.) Loosen the three the Motor rod collar set screws (5/32 Allen).
8) Remove Motor rod and Motor.
9.) Reassemble in reverse order.
Motor Blower Assembly Removal And Installation
1. Remove Belt
2. Disconnect Motor harness connector.
3. Remove Tumbler pulley. Remove ¾" bolt, Next remove pulley using "T" bar puller (needed two 3/8"-16
UNC bolts).
4. Remove Blower back plate (Motor attached). Remove the one, 5/16" harness clamp bolt, then remove
nine 3/8" nuts and then tilt blower fan to remove.
5. Blower fan is held in place with 2 square headed set screws. Upon reassembly, one blower set screw
should fit in the counter sink and the other should mount on the flat side of the shaft.
68
Part # 8533-120-001 9/21
MOTOR WIRES T1, T2, T3
5/32 ALLEN