Dexter Laundry T-750 C4 Installation And Parts & Service Manual page 56

Settings Options:
The Settings options allow for the user to make various programming changes to change how the control
operation affects the customer. See below for detailed information on each next level option.
1. "DECIMAL POINT": If the user programs the Decimal Point to "OFF", control display will not show
2. "DISPLAY TIME": If the user programs this value to "MIN", then minutes only will be shown for
3. "TEMP SCALE": If the user programs this value to "F", then the temperatures will be displayed in
4. "SOUNDS": If the user programs the Sounds to "OFF", the control will not sound the enunciator
5. "PASSWORD": If the user programs the password to any value other then 0000, the control will
6. "CENTRAL PAY": If the user programs this value to "ON", the left and right coin inputs become
Central Pay "OFF"
Left Coin Input
Right Coin Input
A system can then be installed that will register coin inputs per individual dryer remotely from a Central Pay
kiosk. The left and right coin prices must be appropriately programmed. When this option is enabled, the
controller will only display customer prompts for a designated dryer. This designated dryer is determined
when coins are inserted at the Central Pay kiosk.
7. "LANGUAGE": The control uses English for the default language of the customer prompts. Al
56
Part # 8533-120-001 9/21
a decimal point on any vend price values. The factory default is "ON".
the cycle time. If it is programmed to "MIN+SEC", then minutes and seconds will be shown.
This also allows other programming changes, involving time to be made in either minute
increments or minutes & seconds increments, as desired.
Fahrenheit units. If it is programmed to "C", then the temperature will be in Celsius units.
at the end of a dry cycle. The factory default is "ON".
prompt the user to enter a password (the programmed value) before manual programming
can be accessed. The factory default is "0000" (no password).
a. NOTE: that if the user forgets the Password, it can be reset to factory default (no pass
word), by performing a hard reset on the control. Please refer to the appropriate
section of this manual to understand how to perform a hard reset.
b. The individual digits of the Password can be set by using the "UP" or "DOWN" buttons
to change the number that is flashing. Once the desired number is chosen for a
single digit, press the "ENTER" button to move to the next one. Once all
four desired digits are chosen, the "ENTER" button must be held down for
3 seconds to confirm that the complete password should be set.
upper and lower dryer coin inputs.
ternatively, the user can choose Spanish, Maylay, Italian or French for the customer display
prompts. However, all other prompts, such as "MANUAL PROGRAMMING", "USB PROGRAM
ING" and any Error Codes will still display in English.
Central Pay "ON"
Upper Dryer Input
Lower Dryer Input