Dexter Laundry T-750 C4 Installation And Parts & Service Manual page 130

Flat blade screw on
door switch latching
Step 3: With switch actuator bracket adjusted you
will now need to adjust single switch by
loosening 2 flat blade screws and allowing
swivel of switch. Move switch towards above
bracket until it actuates. Now tighten flat
blade screws. Use a .040 thickness gauge to
insert between bracket and switch and the
switch should close and open again upon
removal of thickness gauge.
Door lock rod
Step 5: Check that lock pawl arm swings to cam
lobe to lock position.
130
Part # 8533-120-001 9/21
Locking pawl blocking
Step 4: Check for switch actuation at partial
turn of cam as in operation above. Door
handle goes from horizontal to six o'clock
vertical.
Adjustment screw for
(piggyback switches)
Step 6: The lock stacked switches (piggyback)
must be adjusted as door lock solenoid
pulls up on door rod and locking pawl is
now blocking door cam from turning and
is in full up position. The stacked switches
(piggyback) have a single actuator arm
and it must actuate when single actuator
roller wheel rolls to flat side of locking
pawl. You will also notice a .040 gap
between actuator arm and switch bodies.
NOTE: Both stacked switches must
operate together!
Door cam
check position
Top of flat end
of locking pawl.