Dexter Laundry T-750 C4 Installation And Parts & Service Manual page 59

Usage Menu:
The Usage menu allows for the user to track data about machine usage. See below for detailed information
on each sub menu option.
1. "COIN AUDIT": The coin audit field shows the accumulation of coin pulses that were sent to the
a. The user can also return the coin audit amounts to the factory default setting (zero). To
2. "MOTOR HOURS": The motor hours field shows the accumulated hours of operation. In many
a. The user can also return the motor hours to the factory default setting (zero). To reset
3. "CYCLE HOURS": The cycle hours field shows the accumulated hours of operation. In many
The figure below shows the sub menu options for Usage:
COIN_AUDIT
MOTOR_HOURS
USAGE
CYCLE_HOURS
control over each of the left and right coin inputs.
NOTE: that this is a count of coin pulses, not an accumulated report of vend
value.
reset all coin audit values, press "ENTER" when the "DEFAULT" prompt is shown.
Press "ENTER" again when the "RESET" prompt is shown to confirm the action.
cases, it will match the cycle hours of the machine. However, separate fields are
provided in the event that a motor is replaced on a machine. The user can set the
motor hours to a designated number. For example, if it is necessary to replace the
control on a machine, the new control could be programmed to show the motor
hours that were recorded by the previously installed control. The individual digits
of the hours count can be set by using the "Up" or "Down" buttons to change the
number that is flashing. Once the desired digit of the hours is chosen, press the
"Enter" button to move to the next digit. Once the complete hours are chosen, the
"Enter" button must be held down for 3 seconds to confirm the action.
the motor hours, press "ENTER" when the "DEFAULT" prompt is shown. Press "EN-
TER" again when the "RESET" prompt is shown to confirm the action.
cases, it will match the motor hours of the machine. However, separate
fields are provided in the event that a motor is replaced on a machine. See the Mo
tor Hours description for more information.
LEFT_00000-99999
RIGHT_00000-99999
DEFAULT
SDC, CDC OPTION
DDC OPTION
SDC, CDC OPTION
DDC OPTION
RESET
00000-99999
SET_HOURS 00000-99999
DEFAULT RESET
00000-99999
UPPER MOTOR
SET_HOURS
HOURS
DEFAULT
00000-99999
LOWER MOTOR
SET_HOURS
HOURS
DEFAULT
00000-99999
SET_HOURS 00000-99999
RESET
00000-99999
UPPER CYCLE
SET_HOURS
HOURS
DEFAULT
00000-99999
LOWER CYCLE
SET_HOURS
HOURS
DEFAULT
00000-99999
RESET
00000-99999
RESET
00000-99999
RESET
00000-99999
RESET
Part # 8533-120-001 9/21
59