Dexter Laundry T-750 C4 Installation And Parts & Service Manual page 38

Final Spin:
The washer "Final Spin" is the spin that occurs after all selected baths & intermediate spins have been
completed. It is a higher spin speed then previously occurring intermediate spins. The benefit of this higher
spin speed is that more water is extracted from the wash load, which minimizes the drying time needed.
However, in some cases, if the Dexter installation guidelines are not followed properly, it may be necessary
to reduce the spin speed of the "Final Spin". The control allows for this to occur, based on the menu shown
above.
The Final Spin can be adjusted in increments of 10 G for washers with a 100G maximum spin speed and
increments of 20 G for washers with a 200G maximum spin speed. The factory default final spin speeds are
the maximum values.
Model
T-300
T-350 or T-350 SWD
T-400
T-450 or T-450 SWD
T-600
T-750 or T-750 SWD
T-900
T-950
T-1200
T-1450
Delay Fill:
In some applications, the amount of available water pressure is limited. In these cases, the washer may not
be able to fill the tub in sufficient time to allow for effective washing performance. For this situation, the
control has a "Delay Fill" option that can be chosen based on the menus above.
When the Delay Fill option is "On", the water valves shall be turned on, the washer shall agitate, but the
cycle time shall be paused. The washer shall continue in this state until the proper water level is reached.
Once the proper water level is reached, the cycle shall continue. A single selection of "On" or "Off" shall ap-
ply to all baths in the cycle. The factory default setting is "Off".
Delay Spin:
In some applications, the amount of drain capacity is limited. In these cases the washer cannot empty the
tub in sufficient time to allow for a spin cycle to occur. For this situation, the control has a "Delay Spin" op-
tion that can be chosen based on the menus above.
When a time value (other than 0) is programmed for the Delay Spin option, the end of each bath will be
extended by the selected time. Therefore, extra time will be allowed for the drain valve to be open and
compensate for slow drain capacity. The factory default setting is 0 seconds.
Default Temp:
The "Default Temp" option allows the user to choose which water temperature ("Hot", "Warm", or "Cold")
will be active during Idle mode. The customer can, choose other temperatures for the wash bath based on
other options described in this manual.
38
Part # 8533-120-001 9/21
Adjustable Final Spin Range
60G to 100G
60G to 200G
60G to 100G
60G to 200G
60G to 100G
60G to 200G
60G to 100G
60G to 200G
60G to 100G
60G to 200G