Figure 58. Display Status Indicators - Eaton 9PXM8S4K User Manual

Figure 58. Display Status Indicators

Indicator
Standby Mode
Online Mode
Battery Mode
-
+
1 beep every 10 seconds
End of Backup Time
-
+
1 beep every 3 seconds
High Efficiency Mode
Bypass Mode
7 7 . . 1 1 4 4 C C h h a a n n g g i i n n g g P P a a r r a a m m e e t t e e r r S S e e t t t t i i n n g g s s
The LCD display menus can be selected to show measurements, change control settings and show UPS and
event logs. Use the two middle buttons (
) button to select an option (see
7 7 . . 1 1 5 5 D D i i s s p p l l a a y y M M e e n n u u S S c c r r e e e e n n s s
S S t t a a r r t t S S c c r r e e e e n n
The start screen shows the required information at first startup.
Status
The UPS is Off, waiting for startup command
from user. The indicator flashes
continually.
The UPS is operating normally. The
indicator is on steady.
A utility failure has occurred and the UPS is on
Battery mode.
The UPS is on Battery mode and the battery is
running low.
The UPS is operating on High Efficiency mode.
An overload or a fault has occurred, or a
command has been received, and the UPS is in
Bypass mode.
and ) to scroll through the menu screens then press the Enter (
Figure 60 ).
4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 10
Changing Parameter Settings
Description
Equipment is not powered until button is
pressed. Green LED blinking when UPS is
in Standby mode.
The UPS is powering and protecting the
equipment.
The UPS is powering the equipment with the
battery power.
Prepare your equipment for shutdown.
Low Battery Warning settings: [Capacity] [0%]...
[100%]
[Runtime] [0mn]...[60mn]
The alarm triggers when the set percentage of
battery
capacity or remaining back-up time is reached.
The UPS is powering and protecting the
equipment
Equipment is powered but not protected by the
UPS.
73