4 4 . . 2 2
U U P P S S E E l l e e c c t t r r i i c c a a l l I I n n s s t t a a l l l l a a t t i i o o n n
Only qualified service personnel (such as a licensed electrician) should perform the electrical installation. Risk of
electrical shock.
To prevent electrical shock or damage to the equipment, verify that the Eaton 9PXM UPS is OFF before you
remove the terminal covers. The circuit breaker or disconnect switch must also be OFF at the AC input service
panel.
To install the UPS without an external bypass switch:
1.
Install the AC terminal upper covers supplied in the accessory kit of the UPS (See
input terminal block is located on the lower right side and the AC output on the upper right side of the UPS
rear panel.
Figure 33. UPS Power Terminals
4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 10
UPS Electrical Installation
Figure 33
AC Output Terminals
Terminal Cover
AC Input Terminals
Terminal Cover
) . The AC
37