Table of Contents
Advertisement
Connected Battery Cabinet With No AC Input
2.
If you are rack-mounting the EBM cabinet, refer to the UPS rack-mount installation procedure (see
2.6 Rack-Mount Installation
3.
Install the anchor brackets to the floor if applicable (see
4.
Push in the EBM DC emergency disconnect switch on the rear EBM panel and turn the switch lockout key
(see ).
NOTE
5.
Route the EBM DC input/output cables to the terminal blocks as shown in
NOTE
6.
Connect the EBM DC Cables to the applicable terminals by removing and reinstalling the screws onto the
terminal blocks. See
Figure 41. Connected EBM (No AC Input Option)
From previous
DC+
EBM
DC-
(if installed)
48
4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 10
). If not, proceed to the next step.
The UPS and EBM AC/DC terminal covers are shipped in the UPS and EBM accessory
kit and do not come installed on the UPS or EBM chassis.
Torque the screws holding all input and output power conductors to the values specified
in
Table 2
.
Figure
41.
CN4
CN3
DC+
DC-
EBM
Screws
Cover
Terminal
Block
DC+ DC- DC- DC+
DC input cables from
upstream EBM
(if installed)
2.5 Anchor Bracket Installation
CN4
UPS
Screws
Ground
Lug
Terminal
Block
G
L1 N L2
To UPS
).
(Figure
41).
G
L1
N
L2
Advertisement
Table of Contents
