Table of Contents
Advertisement
Rack-Mount Installation
3.
Remove the cabinet from the castor cart as follows ( see
a.
Lower the leveling feet to stabilize the castor cart.
b.
Remove the rear bracket and screws.
c.
Using two people, slide the cabinet backwards to disengage it from the slot tabs.
Figure 12. Remove Cabinet from Castor Tray
4.
Carefully slide the UPS from the caster tray onto the rail tray in the equipment rack until the rack-mount
ears of the cabinet are almost flush with the front vertical rails of the rack. Install metal clip nuts in the rack
in line with the upper mounting brackets. Install the provided screws.
5.
Install the provided screws into the lower rack mount ears to the threaded holes in the rail tray.
Figure 13. Securing the UPS in the Rack
6.
If you are installing an optional EBM cabinet refer to,
5.1 Battery Cabinet
14
4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 10
Rear Bracket
Screws
Screws
Options".
Figure 12
).
UPS Cabinet
Note: Attach appropriate
lifting device and use at
least two people to lift the
UPS cabinet
Slot Tabs
Caster Tray
Equipment Rack
Rails
Rail Tray
Rack Mount
Ears
"5.2 Standard Battery Cabinet
Installation" or "
Advertisement
Table of Contents
