Nat - HIKVISION DS-7600NI-K1 Series User Manual

Steps
1. Go to Configuration → Network → General → DDNS .
2. Check Enable.
3. Select a DDNS type.
4. Enter parameters including service address, domain name, etc.
5. Click Apply.
What to do next
You can view DDNS status in Status.

6.2.3 NAT

Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
Enable the UPnP™ function of your router if UPnP™ is required. When the device network working
mode is multi-address, the default device route should be on the same network segment as the
LAN IP address of the router.
Steps
1. Configuration → Network → General → NAT .
2. Check Enable.
3. Select Mapping Type as Manual or Auto
Auto The port mapping items are read-only, and the external ports are set by the router
automatically. You can click Refresh to get the latest status of the port mapping.
Manual Select an external port type. Click
external port No., or change it according to actual requirements. External Port
indicates the port No. for port mapping in the router.
The value of the RTSP port No. should be 554 or between 1024 and 65535, while
the value of the other ports should be between 1 and 65535 and the value must be
Network Video Recorder User Manual
Figure 6-4 DDNS
to edit External Port. You can use the default
41