Ddns - HIKVISION DS-7600NI-K1 Series User Manual

The parameters of the two NIC cards can be configured independently. You can select
LAN1 or LAN2 in the NIC type field for parameter settings. You can select one NIC card as
default route. And then the system is connecting with the extranet and the data will be
forwarded through the default route.
Net-fault Tolerance Mode
The two NIC cards use the same IP address, and you can select the Main NIC to LAN1 or
LAN2. By this way, in case of one NIC card failure, the video recorder will automatically
enable the other standby NIC card so as to ensure the normal running of the whole
system.
Load Balance Mode
By using the same IP address and two NIC cards share the load of the total bandwidth,
which enables the system to provide two Gigabit network capacity.
Note
Working mode is only available for certain models.
NIC Type
Select NIC type as your desire. If your device supports Wi-Fi dongle function, the NIC of Wi-Fi
dongle would be selectable after a suitable Wi-Fi dongle is installed.
DHCP
If the DHCP server is available, you can check Enable DHCP to automatically obtain an IP
address and other network settings from that server.
MTU
The maximum transmission unit (MTU) is the size of the largest network layer protocol data
unit that can be communicated in a single network transaction.
Default Route
Select a route as your desire. If your device supports Wi-Fi dongle function, the route of Wi-Fi
dongle would be selectable after a suitable Wi-Fi dongle is installed.
Auto Obtain DNS
If DHCP is checked. You can check Obtain DNS Automatically to obtain Preferred DNS Server
and Alternate DNS Server.
3. Click Apply.

6.2.2 DDNS

Dynamic domain name server (DDNS) maps dynamic user IP addresses to a fixed domain name
server.
Before You Start
Register DynDNS, PeanutHull and NO-IP services with your ISP.
Network Video Recorder User Manual
40