Table of Contents
Advertisement
The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL/TLS
Check to enable SSL/TLS if required by the SMTP server.
Sender
The sender's name.
Sender's Address
The sender's address.
Select Receivers
Select the receiver. Up to 3 receivers can be configured.
Receiver
The receiver's name.
Receiver's Address
The e-mail address of the user to be notified.
Enable Attached Picture
Check to send e-mail with attached alarm images. The interval is the time between sending
two subsequent alarm images.
3. Click Apply.
4. Optional: Click Test to send a test email.
11.5 Configure Port Mapping (NAT)
Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is
set as multi-address, the Default Route of the device should be in the same network segment as
that of the LAN IP address of the router.
Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP™ function to enable the fast connection of the device
to the WAN via a router without port mapping.
Steps
1. Go to System → Network → TCP/IP → NAT.
Network Video Recorder User Manual
97
Advertisement
Table of Contents
