Panasonic KX-TD1232JT Programming Manual page 70

2.2 System Programming
3.
Keep pressing SELECT until the desired selection in Area 1 is displayed.
4.
Press
5.
Keep pressing SELECT until the desired selection in the Area is displayed.
6.
Repeat steps 4 and 5 until all the required entries are completed.
7.
Press STORE.
If only one system is in operation, go to step 10.
8.
Press NEXT to programme the Slave System.
Display example: Slave :C ;E1;E2
9.
Repeat steps 3 through 7, if required.
10.
Press END.
Conditions
• The following units can be installed in the slots.
– C (4-CO lines): KX-TD180
– S1 (2-ISDN S0 lines): KX-TD280
– S2 (6-ISDN S0 lines): KX-TD286
– S3 (1-PRI ISDN line): KX-TD290
– EM (4-E&M lines): KX-TD184
– E, E1, E2 (8-Extension lines): KX-TD170, KX-TD144 or KX-TD146
• There are two expansion areas in the KX-TD816, areas 1 and 2 from bottom to top. One
extension line unit and one outside line (CO / ISDN S0 / E&M) unit can be installed.
• There are three expansion areas in each system for the KX-TD1232, areas 1, 2 and 3 from
bottom to top. Up to two extension line units and one outside line (CO / ISDN S0 / E&M)
unit can be installed. The PRI ISDN line unit can be installed with the ISDN S0 line unit,
but not with the analogue outside line unit.
• An out-of-service system is unassignable. In this case, skip steps 8 and 9 for the KX-
TD1232.
• For the KX-TD1232, if only the Slave System is in operation, the display shows "Slave" in
step 2.
• After changing the setting, turn the Power Switch off and on once. Otherwise, the previous
setting will remain.
Features Guide References
None
70
to programme another Area, if required.
General Programming