2.3 Timer Programming
[208] Inter Digit Time
Description
Assigns the maximum time allowed between digits on an outgoing toll call. If an extension user
fails to dial any digits during this time, the DTMF (Dual Tone Multi-Frequency) receiver is
released. This timer applies until the Toll Restriction check is completed.
Selection
Time (seconds): 5 through 30
Default
10 s
Programming
1.
Enter 208.
Display: Inter Digit Time
2.
Press NEXT.
Display example: Time:10 sec
3.
Enter the time.
To change the current entry, press CLEAR and enter the new time.
4.
Press STORE.
5.
Press END.
Conditions
• This timer is used for toll restriction checking.
• You cannot leave the entry empty.
Features Guide References
Toll Restriction
104
General Programming